-If this hanger mould can work full automatic or not?

Yes, sure. Must 100% work full automatic. but the runner will connect with hangers after take out from mould.

-If this hanger mould can designed much more cavities?

Yes, can be. always depend on client’s QTY. demands.

-If this mould easy fill material and will get air vent or not?

Easy fill material as big gate designed, and we already made air vent on the mould then no problem for air vent.

-If this hanger mould easy get flash or not?

Not easy, as we make all ejectors holes by slow wire line cutting always. And PS material always not easy get flash.

If need more information about this mould, pls contact with us. tks!

Technology

1) Mould structure design

Professional designers provide you with reasonably designed mould to shorten cycle hours.

Reducing unnecessary procedure improves efficiency.

2) Mould cooling system

According to the structural characteristics of the product and the appearance of the product , We design a reasonable form of gate for mould, such as a large gate, hidden gate, fan gate, needle gate, pin point gate etc., a reasonable channel of runner design make mold temperature balance in the shortest time to improve mould precision and productivity.

3) Accessory for mould

Slide, guide pin, guide sleeve, lifter blocks and so on are taken by wear-resistant standard parts, to ensure the mould life. 

4) Deal with mould

Quenching the mold, heat treatment to improve the hardness, then Nitriding temperature is lower , the mold will no longer need to quench mold with high surface hardness and wear resistance more than HV850

Service

1) We can repair the mould in one year for some free and provide technology. . 

2) Gurantee  period is 12months starting from the date of moulds accept in the Buyer’s factory.

3) If the moulds happen the big problem, The moulds cannot repaired, the Buyer cannot solve the problems,eg, mould crack, product  can’t moulding…any big problem(except the human error) due to the mould life can’t reach to guranteed shots.the Seller and Buyer's negotiate to slove the problem, the buyer can send it back to the factory to repair or If serious, the Seller have resposiblity to make new mould for the Buyer.